Data Monitor
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Item [Unit] |
Description | |
|---|---|---|
| IGN VOLT | [V] | Displays the ignition power supply voltage. |
| CONTROL MODULE MALF | [Off / On] | Displays chassis control module malfunction. |
| CAN DIAG STATUS | [Off / On] | Displays CAN network diagnosis status. |
| VEHICLE SPEED | [km/m] | Displays the vehicle speed. |
| FR WHEEL SPEED | [RPM] | Displays the rotational speed of front RH tire. |
| FL WHEEL SPEED | [RPM] | Displays the rotational speed of front LH tire. |
| RR WHEEL SPEED | [RPM] | Displays the rotational speed of rear RH tire. |
| RL WHEEL SPEED | [RPM] | Displays the rotational speed of rear LH tire. |
| STEERING ANG SENSOR | [deg] | Displays the steering angle from the steering angle sensor. |
| DECEL G SENSOR | [G] | Displays the decel G. |
| SIDE G SENSOR | [G] | Displays the side G. |
| YAW RATE SENSOR | [deg/s] | Displays the yaw rate. |
| ACCELE PEDAL POSITION | [%] | Displays the accelerator pedal position. |
| THROTTLE CONTROL | [NORMAL / INCORR / PREV / INPOSSI] | Displays the electric throttle status. |
| SHIFT POSITION | [Off / P / R / N / D (A) / S / L / B / 1- 6 / M 1 -M 8 / A 1 - A 6] | Displayed but not used. |
| BRAKE SWITCH 2 | [Off / On] | Displays brake switch operating status (Off: close / On: open). |
| BRAKE SWITCH 1 | [Off / On] | Displays brake switch operating status (Off: open / On: close). |
| STOP LAMP SW | [INACTIVE / ACTIVE] | Displays the brake status. |
| PRESS SENSOR | [bar] | Displays the brake fluid pressure. |
| ABS | [NORMAL / ABNOR] | Displays ABS function status. |
| ABS MALF | [NORMAL / ABNOR] | Displays ABS function status. |
| EBD | [NORMAL / ABNOR] | Displays EBD function status. |
| TCS | [NORMAL / ABNOR] | Displays TCS function status. |
| TCS MALF | [NORMAL / ABNOR] | Displays TCS function status. |
| VDC | [NORMAL / ABNOR] | Displays VDC function status. |
| VDC MALF | [NORMAL / ABNOR] | Displays VDC function status. |
| VDC OFF SWITCH | [Off / On] | Displays VDC OFF switch status. |
| DRV TRQ CTRL MODE | [INITIAL / NORMAL / STOP 1 / STOP 2 / LIMIT 1 / PROHIBI] | Displays the status of correction to slightly increase/decrease the drive torque. |
| DRV TRQ CTRL PERMIS 1 | [NO PER / PERMIS] | Displays the permission status (basic requirement) of correction to slightly increase/decrease drive torque. |
| DRV TRQ CTRL PERMIS 2 | [NO PER / PERMIS] | Displays the permission status (system requirement) of correction to slightly increase/decrease drive torque. |
| DRV TRQ CTRL STOP | [REQ / NO REQ] | Displays the stop request status of correction to slightly increase/decrease drive torque. |
| DRV TRQ CTRL PROHIBIT | [REQ / NO REQ] | Displays the precaution request status of correction to slightly increase/decrease drive torque. |
| ATC SETTING | [Off / On] | Displays active trace control status. |
| AEB CVT PERMIT | [Off / On] | Displays the CVT authorized state for active engine brake. |
| AEB STATUS | [Off / On] | Displays the active engine brake status. |
| AEB COMMAND 1 | [0.0000] | Displays the relative command value of active engine brake. |
| AEB COMMAND 2 | [0.0000] | Displays absolute command value of active engine brake. |
| AEB SLIP RATE | [%] | Displays slip ratio of active engine brake. |
| AEB SETTING | [Off / On] | Displays active engine brake control status. |