Diagnostic Test

With CONSULT

1. Start engine and warm it up to normal operating temperature.
2. Select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT.
3. Clear mixture ratio self-learning value by touching "CLEAR".

Without CONSULT

1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF.
3. Disconnect mass air flow sensor harness connector.
4. Restart engine and let it idle for at least 5 seconds.
5. Stop engine and reconnect mass air flow sensor harness connector.
6. Check DTC. Make sure DTC P0102 is detected.
7. Erase the DTC P0102. Refer to ON BOARD DIAGNOSIS FUNCTION .
8. Check DTC. Make sure DTC P0000 is detected.

END