Diagnostic Test
- CHECK TERMINALS AND HARNESS CONNECTORS
Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace the malfunctioning parts.
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Repair or replace the malfunctioning parts.
- PERFORM SELF-DIAGNOSIS
With CONSULT
- Erase self-diagnostic results for EPS.
- Turn the ignition switch OFF, and then wait 10 seconds and more.
- Perform self-diagnosis for EPS.
Is DTC C1607 or C1608 detected?
YES
Replace EPS control unit. Refer to REMOVAL AND INSTALLATION .
NO
Check intermittent incident. Refer to INTERMITTENT INCIDENT .