Diagnostic Test
- CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to DIAGNOSIS PROCEDURE .
GO TO STEP 2 .
- PERFORM SELF-DIAGNOSIS RESULT
Select "Self Diagnostic Result" mode of "BCM", and check if DTC is detected.
Is DTC detected?
YES
Perform the trouble diagnosis for the detected DTC.
NO
GO TO STEP 3 .
- CHECK "ENGINE START BY I-KEY" SETTING IN "WORK SUPPORT"
- Select "INTELLIGENT KEY" of "BCM" using CONSULT.
- Select "ENGINE START BY I-KEY" of "Work support" mode.
- Check "ENGINE START BY I-KEY" in "Work support".
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Set "On" in "ENGINE START BY I-KEY".
- CHECK INSIDE KEY ANTENNA
Use SIGNAL TECH II to check each inside key antenna. For the inspection method and how to use SIGNAL TECH II, refer to "NISSAN/INFINITI SIGNAL TECH II USER GUIDE".
Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Repair or replace malfunctioning parts.
- REPLACE BCM
- Replace BCM. Refer to REMOVAL AND INSTALLATION .
- Check operation after replacement.
Is the inspection result normal?
YES
Inspection End.
NO
Check intermittent incident. Refer to INTERMITTENT INCIDENT .