Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK DTC OF COMBINATION METER
   
   

   Check DTC in "Self Diagnostic Result" mode of "METER/M&A" using CONSULT.

   Refer to DTC INDEX .

   Is the inspection result normal?

   YES 

   GO TO STEP 2  .

   NO 

   Repair or replace the malfunctioning parts.

2. CHECK FUSE
   
   
   1. Turn power switch OFF.
   2. Check that the following fuse in the fuse block (J/B) is not blown.

      Signal name	Fuse No.
      Ignition power supply	5 (10 A)

   Is the inspection result normal?

   YES 

   GO TO STEP 3  .

   NO 

   Replace the blown fuse after repairing the cause of blowing.

3. CHECK CLUTCH PEDAL POSITION SWITCH POWER SUPPLY
   
   
   1. Disconnect clutch pedal position switch connector.
   2. Turn ignition switch ON.
   3. Check voltage between clutch pedal position switch harness connector and ground.

      (+)		(-)	Voltage (V) (Approx.)
      Clutch pedal position switch
      Connector	Terminal
      E32	1	Ground	Battery voltage

   Is the inspection result normal?

   YES 

   GO TO STEP 4  .

   NO 

   Repair or replace harness.

4. CHECK CLUTCH PEDAL POSITION SWITCH SIGNAL
   
   
   1. Connect clutch pedal position switch connector.
   2. Check voltage between BCM harness connector and ground.

      (+)		(-)	Condition		Voltage
      BCM
      Connector	Terminal
      M84	37	Ground	Clutch pedal	Released	Battery voltage
      				Depressed	0 - 1.5 V

   Is the inspection result normal?

   YES 

   GO TO STEP 5  .

   NO 

   GO TO STEP 6  .

5. REPLACE BCM
   
   
   1. Replace BCM. Refer to REMOVAL AND INSTALLATION .
   2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

   Inspection End

6. CHECK CLUTCH PEDAL POSITION SWITCH CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect BCM connector.
   3. Check continuity between clutch pedal position switch harness connector and BCM harness connector.

      Clutch pedal position switch		BCM		Continuity
      Connector	Terminal	Connector	Terminal
      E32	2	M84	37	Yes

   Is the inspection result normal?

   YES 

   GO TO STEP 7  .

   NO 

   Repair or replace harness.

7. CHECK CLUTCH PEDAL POSITION SWITCH
   
   

   Refer to COMPONENT INSPECTION .

   Is the inspection result normal?

   YES 

   GO TO STEP 8  .

   NO 

   Replace clutch pedal position switch. Refer to EXPLODED VIEW .

8. CHECK INTERMITTENT INCIDENT
   
   

   Refer to INTERMITTENT INCIDENT .

   Inspection End