LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2017 >> Sentra S, Standard Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Sensor ID Registration Using Signal Tech II (With CONSULT)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor ID Registration Using Signal Tech II (With CONSULT)

NOTE: The Signal Tech II must be updated with software version 1.1.48 or newer in order to perform the below procedures. The Signal Tech II software updates can only be downloaded from a CONSULT unit with ASIST. Other versions of ASIST will not show the updates.
  1. With the ignition switch in OFF position, connect CONSULT scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Using CONSULT, select WORK SUPPORT in AIR PRESSURE MONITOR. Then, select ID REGIST.
  3. Select START on ID REGIST screen.
  4. Turn on the Signal Tech II.
  5. Hold the Signal Tech II against the side of the left front tire, near the valve stem. See Figure.
  6. With the tool held at a 0 to 15 degree angle to the tire, select ACTIVATE SENSOR from the main menu, then press and release the OK button to activate the sensor. Once the sensor is activated, the vehicle parking lamps will flash and the sensor ID will appear on the CONSULT screen.
  7. Repeat tool procedure for the remaining tires in this order: Right Front, Right Rear And Left Rear.
  8. As each sensor ID is registered, the turn signal lights flash twice.
  9. After completing all ID registrations, press END on the CONSULT to complete the procedure.
  10. Test drive the vehicle to ensure that the TPMS lamp is OFF and no warning messages are present.
scientia non olet · About LEMON Manuals