April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure

CAUTION:

Use "Manual Configuration" only when "TYPE ID" of ADAS control unit cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING TYPE ID (1)

Use FAST (service parts catalogue) to search ADAS control unit of the applicable vehicle and find "Type ID".

Is "Type ID" displayed?

YES

Print out "Type ID" and GO TO STEP 2 .

NO

"Configuration" is not required for ADAS control unit. Replace in the usual manner. Refer to REMOVAL AND INSTALLATION .

CHECKING TYPE ID (2)

CONSULT Configuration
1. Select "Before Replace ECU" of "Read/Write Configuration".
2. Check that "Type ID" is displayed on the CONSULT screen.
Is "Type ID" displayed?

YES

GO TO STEP 3 .

NO

GO TO STEP 7 .

VERIFYING TYPE ID (1)

CONSULT Configuration

Compare a "Type ID" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Type ID" agree with each other.

NOTE:
For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

GO TO STEP 4 .

SAVING TYPE ID

CONSULT Configuration

Save "Type ID" on CONSULT.

GO TO STEP 5 .

REPLACING ADAS CONTROL UNIT (1)

Replace ADAS control unit. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 6 .

WRITING (AUTOMATIC WRITING)

CONSULT Configuration
1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
2. Select the "Type ID" agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue) to write the "Type ID" into the ADAS control unit.
  NOTE:
  For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".
GO TO STEP 9 .

REPLACING ADAS CONTROL UNIT (2)

Replace ADAS control unit. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 8 .

WRITING (MANUAL WRITING)

CONSULT Configuration
1. Select "Manual Configuration".
2. Select the "Type ID" searched by using FAST (service parts catalogue) to write the "Type ID" into the ADAS control unit.
  NOTE:
  For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".
GO TO STEP 9 .

VERIFYING TYPE ID (2)

Compare "Type ID" written into the ADAS control unit with the one searched by using FAST (service parts catalogue) to check that these "Type ID" agree with each other.

NOTE:
For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

GO TO STEP 10 .

RESTART ADAS BY IGN OFF/IGN ON
1. Turn the ignition switch OFF.
2. Turn the ignition switch ON.
GO TO STEP 11 .

PERFORMING SUPPLEMENTARY WORK
1. Perform "Self Diagnostic Result" of all systems.
2. Erase "Self Diagnostic Result".
End of work.