| B2192: ID DISCORD BCM-ECM |
Inhibit engine cranking |
Erase DTC |
| B2193: CHAIN OF BCM-ECM |
Inhibit engine cranking |
Erase DTC |
| B2195: ANTI-SCANNING |
Inhibit engine cranking |
Ignition switch ON → OFF |
| B2560: START POW SUP CIRC |
Inhibit engine cranking |
500 ms after the following CAN signal communication status has become consistent:
- Starter control relay signal
- Starter relay status signal
|
| B2562: LOW VOLTAGE |
Inhibit engine cranking |
100 ms after the power supply voltage increases to more than 8.8 V |
| B2608: STARTER RELAY |
Inhibit engine cranking |
500 ms after the following signal communication status becomes consistent:
- Starter motor relay control signal
- Starter relay status signal (CAN)
|
| B260A: IGN RELAY |
Inhibit engine cranking |
500 ms after the following conditions are fulfilled:
- IGN relay (IPDM E/R) control signal: OFF (Battery voltage)
- Ignition ON signal (CAN to IPDM E/R): OFF (Request signal)
- Ignition ON signal (CAN from IPDM E/R): OFF (Condition signal)
|
| B261E: FUEL MIS CONFIG |
Inhibit engine cranking |
BCM initialization |