Diagnostic Test
- EXHAUST VALVE TIMING (EVT) CONTROL POSITION SENSOR-I
- Turn ignition switch OFF.
- Disconnect EVT control position sensor harness connector.
- Loosen the fixing bolt of the sensor.
- Remove the sensor. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Replace camshaft position sensor. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .
- CHECK CAMSHAFT POSITION SENSOR-II
Check resistance camshaft position sensor terminals as follows.
Terminals (Polarity) Resistance [at 25°C (77°F)] 1 (+) - 2 (-)
Except 0 or ∞Ω1 (+) - 3 (-) 2 (+) - 3 (-) Is the inspection result normal?
YES
INSPECTION END
NO
Replace camshaft position sensor. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .