Diagnostic Test
- CHECK THROTTLE POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Perform DESCRIPTION .
- Turn ignition switch ON.
- Set selector lever to D (CVT) or 1st (M/T) position.
- Check the voltage between ECM harness connector and ground.
ECM Condition Voltage Connector Terminal + - F11 33
(TP sensor 1 signal)36 Accelerator pedal Fully released More than 0.36 V Fully depressed Less than 4.75 V 34
(TP sensor 2 signal)Fully released Less than 4.75 V Fully depressed More than 0.36 V
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO STEP 2 .
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace electric throttle control actuator. Refer to REMOVAL AND INSTALLATION .
INSPECTION END