Data Monitor
|
Monitor Item [Unit] |
Main |
Description |
|
CONFRM ID ALL [Yet/DONE] |
X |
Indicates condition of Intelligent Key ID authentication. |
|
CONFIRM ID4 [Yet/DONE] |
X |
Indicates condition of Intelligent Key ID authentication. |
|
CONFIRM ID3 [Yet/DONE] |
X |
Indicates condition of Intelligent Key ID authentication. |
|
CONFIRM ID2 [Yet/DONE] |
Indicates condition of Intelligent Key ID authentication. |
|
|
CONFIRM ID1 [Yet/DONE] |
X |
Indicates condition of Intelligent Key ID authentication. |
|
NOT REGISTERED [Yet/ID OK] |
Indicates condition of stop lamp switch. |
|
|
TP 4 [Yet/DONE] |
X |
Indicates if the ID of fourth key is registered to Intelligent Key unit. |
|
TP 3 [Yet/DONE] |
Indicates if the ID of third key is registered to Intelligent Key unit. |
|
|
TP 2 [Yet/DONE] |
Indicates if the ID of second key is registered to Intelligent Key unit. |
|
|
TP 1 [Yet/DONE] |
Indicates if the ID of first key is registered to Intelligent Key unit. |
|
|
TP 4 (Registration mode) [Yet/DONE] |
Indicates if the ID of fourth key is registered to Intelligent Key unit. |
|
|
TP 3 (Registration mode) [Yet/DONE] |
Indicates if the ID of third key is registered to Intelligent Key unit. |
|
|
TP 2 (Registration mode) [Yet/DONE] |
X |
Indicates if the ID of second key is registered to Intelligent Key unit. |
|
TP 1 (Registration mode) [Yet/DONE] |
Indicates if the ID of first key is registered to Intelligent Key unit. |
|
|
Request SW (DR) [On/Off] |
Indicates when driver door request switch is pressed. |
|
|
Request SW (AS) [On/Off] |
Indicates when passenger door request switch is pressed. |
|
|
Request SW (BD) [On/Off] |
Indicates when back door request switch is pressed. |
|
|
PUSH SW [On/Off] |
Indicates when ignition switch is pressed |
|
|
DETE/CANCL SW [On/Off] |
X |
Indicates selector lever position. |
|
SHFTLCK SLNID PWR SPLY [On/Off] |
X |
Indicates condition of power supply to shift lock solenoid |
|
PUSH SW -IPDM [On/Off] |
X |
Indicates when ignition switch is pressed |
|
IGN RLY1 -F/B [On/Off] |
Indicates condition of ignition request from IPDM E/R on CAN communication line. |
|
|
SFT PN -IPDM [On/Off] |
Indicates selector lever position. |
|
|
STARTER RELAY -IPDM [On/Off] |
Indicates condition of starter relay from IPDM E/R on CAN communication line. |
|
|
ENGINE STATE [Stop/Stall/Crank/Run] |
Indicates condition of engine state from IPDM E/R on CAN communication line. |
|
|
ST/INHI RELAY -IPDM [On/Off] |
Indicates condition of ST/INHI relay from IPDM E/R on CAN communication line. |
|
|
REVERSE SIGNAL -IPDM [On/Off] |
Indicates condition of reverse position from IPDM E/R on CAN communication line. |
|
|
CRANKING PERMIT -ECM [Permit/Not permit] |
Indicates cranking permission from ECM on CAN communication line. |
|
|
VEH SPEED 1 [Km/h/mph] |
Indicates vehicle speed. |
|
|
VEH SPEED 2 [Km/h/mph] |
Indicates vehicle speed. |
|
|
IGN REQ- IPDM [On/Off] |
Indicates condition of ignition request from IPDM E/R on CAN communication line. |
|
|
STARTER REQ -IPDM [On/Off] |
Indicates condition of starter request from IPDM E/R on CAN communication line. |
|
|
DOOR STAT-DR [LOCK/READY/UNLK] |
X |
Indicates condition of driver side door status. |
|
DOOR STAT-AS [LOCK/READY/UNLK] |
X |
Indicates condition of passenger side door status. |
|
DOOR STAT-RR [LOCK/READY/UNLK] |
X |
Indicates condition of rear right side door status. |
|
DOOR STAT-RL [LOCK/READY/UNLK] |
X |
Indicates condition of rear left side door status. |
|
BK DOOR STATE [LOCK/READY/UNLK] |
X |
Indicates condition of back door status. |
|
ID OK FLAG [Set/Reset] |
Indicates condition of Intelligent Key ID. |
|
|
PRMT ENG STRT [Set/Reset] |
Indicates condition of engine start possibility. |
|
|
PRMT RKE STRT [Set/Reset] |
Indicates condition of engine start possibility from Intelligent Key. |
|
|
I-KEY OK FLAG [Key ON/Key OFF] |
X |
Indicates condition of Intelligent Key OK flag. |
|
PRBT ENG STRT [Set/Reset] |
Indicates condition of engine start prohibit. |
|
|
ID AUTHENT CANCEL TIMER [STOP] |
Indicates condition of Intelligent Key ID authentication. |
|
|
ACC BATTERY SAVER [STOP] |
Indicates condition of battery saver. |
|
|
CRNK PRBT TMR [On/Off] |
Indicates condition of crank prohibit timer. |
|
|
CRNK PRBT TME [sec] |
Indicates condition of engine crank prohibit time. |
|
|
AUT CRANK TMR [sec] |
Indicates the time that AUTO CRANKING MODE operates |
|
|
CRANKING TME [sec] |
Indicates condition of engine cranking time from Intelligent Key. |
|
|
SHORT CRANK [Ok/NG] |
Indicates condition of engine cranking time from Intelligent Key. |
|
|
I-KEY assess key FOB #1 location [N/regist/regist] |
X |
Indicates if the ID of first key is registered to Intelligent Key unit. |
|
I-KEY assess key FOB #2 location [N/regist/regist] |
X |
Indicates if the ID of second key is registered to Intelligent Key unit. |
|
I-KEY assess key FOB #3 location [N/regist/regist] |
Indicates if the ID of third key is registered to Intelligent Key unit. |
|
|
I-KEY assess key FOB #4 location [N/regist/regist] |
Indicates if the ID of fourth key is registered to Intelligent Key unit. |
|