April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Supply Position Change Table By Push-Button Ignition Switch Operation

The power supply position changing operation can be performed with the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operating condition
- Selector lever position
- Vehicle speed

Vehicle speed: less than 4 km/h (2.5 MPH)

Power supply position	Engine start/stop condition		Push-button ignition switch operation frequency
Power supply position	Selector lever	Brake pedal operation condition	Push-button ignition switch operation frequency
LOCK → ACC	-	Not depressed	1
LOCK → ACC → ON	-	Not depressed	2
LOCK → ACC → ON → OFF	-	Not depressed	3
LOCK → START ACC → START ON → START	P or N position	Depressed	1
Engine is running → OFF	-	-	1

Vehicle speed: 4 km/h (2.5 MPH) or more

Power supply position	Engine start/stop condition		Push-button ignition switch operation frequency
Power supply position	Selector lever	Brake pedal operation condition	Push-button ignition switch operation frequency
Engine is running → ACC	-	-	Emergency stop operation
Engine stall return operation while driving	N position	Not depressed	1

Emergency stop operation

Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 times or more within 1.5 seconds.