Ignition Switch Position Change Table By Push-Button Ignition Switch Operation

WARNING: This page is about a different car, the 2018 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

The ignition switch position can be changed by the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna or when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions,
CVT models
- Brake pedal operation condition
- Selector lever position
- Vehicle speed
M/T models
- Clutch pedal operation condition
- Vehicle speed

Vehicle speed: less than 4 km/h (2.5 MPH)

Power supply position	Condition			Push-button ignition switch operation frequency
	CVT models		M/T models
	Selector lever	Brake pedal operation condition	Clutch pedal operation condition
OFF → ACC	-	Not depressed	Not depressed	1
OFF → ACC → ON	-	Not depressed	Not depressed	2
OFF → ACC → ON → OFF	-	Not depressed	Not depressed	3
OFF → START ACC → START ON → START	P or N position	Depressed	Depressed	1
Engine is running → OFF	-	-	-	1

Vehicle speed: 4 km/h (2.5 MPH) or more

Power supply position	Condition			Push-button ignition switch operation frequency
	CVT models		M/T models
	Selector lever	Brake pedal operation condition	Clutch pedal operation condition
Engine is running → ACC	-	-	-	Emergency stop operation
Engine stall return operation while driving	N position	Not depressed	Depressed	1

Emergency stop operation

Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 times or more within 1.5 seconds.