Values on the Diagnosis Tool

The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

CAUTION: The output signal indicates the EPS control unit calculation data. The normal values will be displayed even in the event that the output circuit (harness) is open.

Monitor item	Data monitor
	Condition		Display value
BATTERY VOLT	Ignition switch: ON		Battery voltage
TORQUE SENSOR	Engine running	Steering wheel: Not steering (There is no steering force)	Approx. 0 Nm
		Steering wheel: Right turn	Positive value (Nm)
		Steering wheel: Left turn	Negative value (Nm)
MOTOR CURRENT	Engine running	Steering wheel: Not steering (There is no steering force)	Approx. 0 A
		Steering wheel: Right or left turn	Displays consumption current of EPS motor (A) ^*1
MOTOR SIG	Engine running	Steering wheel: Not steering (There is no steering force)	Approx. 0 A
		Steering wheel: Right turn	Positive value (A)
		Steering wheel: Left turn	Negative value (A)
ASSIST TORQUE	Engine running		Approx. 0 Nm ^*2
C/U TEMP	Ignition switch ON or engine running		Displays temperature of inside of EPS control unit [°C (°F)]
ASSIST LEVEL	Engine running		100 % ^*3
VEHICLE SPEED	Vehicle stopped		0 km/h (0 mph)
	While driving		Approximately equal to the indication on speedometer ^*4 (inside of ±10%)
WARNING LAMP	EPS warning lamp: ON		On
	EPS warning lamp: OFF		Off
ENGINE STATUS	Engine not running		Stop
	Engine running		Run

*1: Almost in accordance with the value of "MOTOR SIG". It is not a malfunction though these values are not accorded when steering quickly.

*2: A fixed value is indicated regardless of steering turning.

*3: Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls. However, it returns to 100% when left standing.

*4: It is not a malfunction, though it might not be corresponding just after ignition switch in turned ON.