Ignition Switch Position Change Table By Push-Button Ignition Switch Operation
The ignition switch position can be changed by the following operations:
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna or when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below:
- When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operation condition
- Selector lever position
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
|
Power supply position |
Condition |
Push-button ignition switch operation frequency |
|
|
Selector lever |
Brake pedal operation condition |
||
|
OFF → ACC |
- |
Not depressed |
1 |
|
OFF → ACC →ON |
- |
Not depressed |
2 |
|
OFF → ACC → ON → OFF |
- |
Not depressed |
3 |
|
OFF → START ACC → START ON → START |
P or N position |
Depressed |
1 |
|
Engine is running → OFF |
- |
- |
1 |
Vehicle speed: 4 km/h (2.5 MPH) or more
|
Power supply position |
Condition |
Push-button ignition switch operation frequency |
|
|
Selector lever |
Brake pedal operation condition |
||
|
Engine is running → ACC |
- |
- |
Emergency stop operation |
|
Engine stall return operation while driving |
N position |
Not depressed |
1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.