Component Inspection

1. Turn ignition switch OFF.
2. Disconnect clutch interlock switch harness connector.
3. Check the continuity between clutch interlock switch terminals under the following conditions.

   Terminals	Condition		Continuity
   1 and 2	Clutch pedal	Fully released	Not existed
   		Fully depressed	Existed

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Adjust clutch interlock switch installation.
2. Check the continuity between clutch interlock switch terminals under the following conditions.

   Terminals	Condition		Continuity
   1 and 2	Clutch pedal	Fully released	Not existed
   		Fully depressed	Existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace clutch interlock switch.