Work Procedure

Description 

If any of the following operations are performed, the initialization is necessary for normal operation of the power window system.

• When control unit is replaced.
• Electric power supply to the power window switch or motor is interrupted by blown fuse or disconnection and connection of the negative battery terminal.
• Removal and installation of the regulator assembly.
• Power supply to the main power window and lock/unlock switch or power window motor is cut off by the removal

  of battery terminal or if the battery fuse is blown.

• Disconnection and connection of the main power window and lock/unlock switch harness connector.
• Removal and installation of the motor from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of the door glass.
• Removal and installation of the door glass run.

The following specified operations can not be performed under the non-initialized condition.

• Auto-up operation
• Anti-pinch function

1. CHECK ANTI-PINCH FUNCTION 
   • Fully open the door window.
   • Place a piece of wood near fully closed position.
   • Close door glass completely with AUTO-UP.
   • Check the following conditions
     • Check that the glass lowers without pinching piece of wood and stops.
     • Check that glass does not rise not when operating the main power window and lock/unlock switch while lowering.
       CAUTION:

       • Perform initial setting when AUTO-UP operation or anti-pinch function does not operate normally.
       • Check that AUTO-UP operates before inspection when system initialization is performed.
       • Do not check with hands and other body parts because they may be pinched. Do not get pinched.

   Inspection End.