DTC Detection Logic

NOTE:

If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Description .
If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC Description .

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC Detection Condition
B2604	PNP/CLUTCH SW	Diagnosis condition	When the ignition switch is ON.
		Signal (terminal)	--
		Threshold	The following states are detected for 5 seconds while ignition switch is ON: P/N position signal is sent from TCM but shift position signal input (CAN) from TCM is other than P (Park) and N (Neutral) P/N position signal is not sent from TCM but shift position signal input (CAN) from TCM is P (Park) or N (Neutral)
		Diagnosis delay time	--