Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform Throttle Valve Closed Position Learning. Refer to Description .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage
   Connector	+	-
   	Terminal
   F14	71	75	Accelerator pedal	Fully released	More than 0.36 V
   				Fully depressed	Less than 4.75 V
   	72			Fully released	Less than 4.75 V
   				Fully depressed	More than 0.36 V

Is the inspection result normal?

YES

INSPECTION END

NO

Replace electric throttle control actuator. Refer to Removal and Installation .