DTC Detection Logic
- The crankshaft position Sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking.
- The proper pulse signal from the crankshaft position Sensor (POS) is not sent to ECM while the engine is running.
- The crankshaft position Sensor (POS) signal is not in the normal pattern during engine running.
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|
P0335 |
CKP SEN/CIRCUIT (Crankshaft position Sensor "A" circuit) |
1 |
Diagnosis condition |
Start engine and let it idle |
|
Signal (terminal) |
Voltage signal transmitted from crankshaft position Sensor (POS) to ECM |
|||
|
Threshold |
The crankshaft position Sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking |
|||
|
Diagnosis delay time |
-- |
|||
|
2 |
Diagnosis condition |
Start engine and let it idle |
||
|
Signal (terminal) |
Voltage signal transmitted from crankshaft position Sensor (POS) to ECM |
|||
|
Threshold |
The proper pulse signal from the crankshaft position Sensor (POS) is not sent to ECM while the engine is running |
|||
|
Diagnosis delay time |
-- |
|||
|
3 |
Diagnosis condition |
Start engine and let it idle |
||
|
Signal (terminal) |
Voltage signal transmitted from crankshaft position Sensor (POS) to ECM |
|||
|
Threshold |
The crankshaft position Sensor (POS) signal is not in the normal pattern during engine running |
|||
|
Diagnosis delay time |
-- |
|||