Work Support
|
Work support items |
Description |
|
CAUSE OF AUTO-CANCEL 1 |
Displays causes of automatic system cancellation occurred during control of the following systems
|
|
CAUSE OF AUTO-CANCEL 4 |
Displays causes of automatic system cancellation occurred during control of the following systems
|
- Causes of the maximum five cancellations (system cancel) are displayed.
- The displayed cancellation causes display the number of the ignition switch ON/OFF up to 254. It is fixed to 254 if it is over 254. It returns to 0 when the same cancellation cause is detected again.
Display Items for The Cause of Automatic Cancellation 1
|
Cause of cancellation |
Vehicle-to-vehicle distance control mode |
Conventional (fixed speed) cruise control mode |
Automatic Emergency Braking |
Description |
||
|
OPERATING ABS |
X |
X |
ABS function was operated |
|||
|
OPERATING TCS |
X |
X |
TCS function was operated |
|||
|
OPERATING VDC |
X |
X |
X |
VDC function was operated |
||
|
ECM CIRCUIT |
X |
X |
ECM did not permit ICC operation |
|||
|
OPE SW VOLT CIRC |
X |
X |
The ICC steering switch input voltage is not within standard range |
|||
|
OP SW DOUBLE TOUCH |
X |
X |
ICC steering switches were pressed at the same time |
|||
|
VHCL SPD DOWN |
X |
X |
Vehicle speed lower than the speed as follows
|
|||
|
WHL SPD ELEC NOISE |
X |
X |
Wheel speed sensor signal caught electromagnetic noise |
|||
|
VDC/TCS OFF SW |
X |
X |
VDC OFF switch was pressed |
|||
|
VHCL SPD UNMATCH |
X |
X |
Wheel speed became different from CVT vehicle speed |
|||
|
TIRE SLIP |
X |
X |
Wheel slipped |
|||
|
IGN LOW VOLT |
X |
X |
X |
Decrease in ADAS control unit ignition voltage |
||
|
PARKING BRAKE ON |
X |
X |
The parking brake is operating |
|||
|
WHEEL SPD UNMATCH |
X |
X |
The wheel speeds of 4 wheels are out of the specified values |
|||
|
INCHING LOST |
X |
A vehicle ahead is not detected during the following driving when the vehicle speed is approximately 24 km/h (15 MPH) or less |
||||
|
CAN COMM ERROR |
X |
X |
X |
ADAS control unit received an abnormal signal with CAN communication |
||
|
ABS/TCS/VDC CIRC |
X |
X |
X |
An abnormal condition occurs in VDC/TCS/ABS system |
||
|
ECD CIRCUIT |
X |
X |
X |
An abnormal condition occurs in ECD system |
||
|
ENG SPEED DOWN |
X |
X |
Engine speed became extremely low while controlling ICC system |
|||
|
ASCD VHCL SPD DTAC |
X |
Vehicle speed is detached from set vehicle speed |
||||
|
ASCD DOUBLE COMD |
X |
Cancel switch and operation switch are detected simultaneously |
||||
|
ICC SENSOR CAN COMM ERR |
X |
X |
Communication error between ADAS control unit and the distance sensor (ICC sensor) |
|||
|
ABS WARNING LAMP |
X |
ABS warning lamp ON |
||||
|
FR RADAR BLOCKED |
X |
X |
Inclusion of dirt or stains on the distance sensor (ICC sensor) area of the front bumper |
|||
|
FEB) CURVATURE |
X |
Road curve was more than the specified value |
||||
|
FEB) YAW RATE |
X |
Detected yawing speed was more than the specified value |
||||
|
FEB) LTRL ACCELERATION |
X |
Detected lateral speed is the specified value or more |
||||
|
RADAR INTERFERENCE |
X |
X |
Distance sensor (ICC sensor) receives electromagnetic interference |
|||
|
NO RECORD |
X |
X |
- |
|||