Component Function Check
WARNING: This page is about a different variant/trim than selected.
- START
Make sure that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5, 000 km (3, 107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm 2 , 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30°C (68 - 86°F)
- Engine coolant temperature: 75 - 95°C (167 - 203°F)
- Transmission: Warmed-up
- CVT models: After the engine is warmed up to normal operating temperature, drive vehicle until "FLUID TEMP SE" (CVT fluid temperature sensor signal) indicates more than 60°C (140°F).
- M/T models: After the engine is warmed up to normal operating temperature, drive vehicle for 5 minutes.
- Electrical load: Not applied
- Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
- Engine speed: Idle
GO TO 2.
- PERFORM "SPEC" of "DATA MONITOR" MODE
With CONSULT
NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.- Perform Work Procedure .
- Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MASS AIR FLOW SENSOR (Hz) " in "SPEC" of "DATA MONITOR" mode of "ENGINE" using CONSULT.
- Make sure that monitor items are within the SP value.
Is the inspection result normal?
YES
END
NO
Proceed to Diagnosis Procedure .