Active Test Mode

Test item

Condition

Judgement

Check item (Remedy)

ENG COOLANT TEMP

• Engine: Return to the original trouble condition
• Change the engine coolant temperature using CONSULT.

If trouble symptom disappears, see Check item.

• Harness and connectors
• Engine coolant temperature sensor
• Fuel injector

FUEL INJECTION

• Engine: Return to the original trouble condition
• Change the amount of fuel injection using CONSULT.

If trouble symptom disappears, see Check item.

• Harness and connectors
• Fuel injector
• Air fuel ratio (A/F) sensor 1

PURG VOL CONT/V

• Engine: After warming up, run engine at 1, 500 rpm.
• Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.

Engine speed changes according to the opening percent.

• Harness and connectors
• Solenoid valve

FUEL/T TEMP SEN

Change the fuel tank temperature using CONSULT.

POWER BALANCE

• Engine: After warming up, idle the engine.
• A/C switch OFF
• Selector lever: P or N (CVT), Neutral (M/T)
• Cut off each fuel injector signal one at a time using CONSULT.

Engine runs rough or dies.

• Harness and connectors
• Compression
• Fuel injector
• Power transistor
• Spark plug
• Ignition coil

INT V/T ASSIGN ANGLE

• Engine: Return to the original non-standard condition
• Change intake valve timing using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Intake valve timing control solenoid valve

EXH V/T ASSIGN ANGLE

• Engine: Return to the original non-standard condition
• Change exhaust valve timing using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Exhaust valve timing control solenoid valve

FUEL PUMP RELAY

• Ignition switch: ON
• Engine stopped
• Turn the fuel pump relay "ON" and "OFF" using CONSULT and listen to operating sound.

Fuel pump relay makes the operating sound.

• Harness and connectors
• Fuel pump relay

VENT CONTROL/V

• Ignition switch: ON
• Engine stopped
• Turn solenoid valve ON and OFF with the CONSULT and listen to operating sound.

Solenoid valve makes an operating sound.

• Harness and connectors
• EVAP canister vent control solenoid valve

FAN DUTY CONTROL ^*

• Ignition switch: ON
• Change duty ratio using CONSULT.

Cooling fan speed changes.

• Harness and connectors
• Cooling fan motor
• Cooling fan relay
• Cooling fan control module
• IPDM E/R

ALTERNATOR DUTY

• Ignition switch: ON
• Change duty ratio using CONSULT.

Battery voltage changes.

• Harness and connectors
• Alternator
• IPDM E/R

TUMBLE CONTROL VALVE

• Ignition switch: ON
• Engine stopped
• Turn the intake manifold runner control valve "ON" and "OFF" using CONSULT to open or close.

Touch the intake manifold runner control valve motor and check the operating vibration and sound.

• Harness and connectors
• Intake manifold runner control valve
• Intake manifold runner control valve motor

IGNITION TIMING

• Engine: Return to the original trouble condition
• Timing light: Set
• Retard the ignition timing using CONSULT.

If trouble symptom disappears, see Check item.

Perform Idle Air Volume Learning.

EGR CONTROL VALVE

• Ignition switch: ON
• Engine stopped
• Change valve target angle using CONSULT

Valve opening angle changes according to target angle (from 0deg to 70deg)

• Harness and connectors
• EGR valve

WASTEGATE ACTUATOR

• Ignition switch: ON
• Engine stopped
• Change valve of wastegate actuator target angle using CONSULT

Wastegate valve position sensor voltage changes according to valve target angle

• Harness and connectors
• Electric wastegate control actuator (Removal bypass valve from turbocharger is NG)
• Turbocharger assembly

TC BYPASS VALVE

• Ignition switch: ON
• Engine stopped or Engine running (idling, less than 1200rpm)
• Input "ON" "OFF" signal using CONSULT

Bypass valve makes the operating sound.

• Harness and connectors
• Turbocharger bypass valve (Removal bypass valve from Turbocharger is NG)
• Turbocharger assembly

ENGINE OIL PRESSURE CONTROL SOLENOID VALVE

• Water temperature: > -10°C
• Engine oil temperature: < 120°C (248°F)
• Engine speed: < 4000rpm

Engine oil pressure change

• Harness and connectors
• Engine oil pressure control solenoid valve
• Engine oil pressure sensor
• Engine oil pump