Component Inspection (EVT Control Position Sensor)
- EXHAUST VALVE TIMING (EVT) CONTROL POSITION SENSOR-1
- Turn ignition switch OFF.
- Disconnect EVT control position sensor harness connector.
- Loosen the fixing bolt of the sensor.
- Remove EVT control position sensor.
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2 .
NO
Replace EVT control position sensor. Refer to Exploded View .
- EVT CONTROL POSITION SENSOR-2
Check resistance EVT control position sensor terminals as shown below.
EVT control position sensor
Condition
Resistance
+
-
Terminal
1
2
Temperature °C (°F)
25 (77)
Except 0 or ∞Ω
3
2
3
Is the inspection result normal?
YES
INSPECTION END
NO
Replace EVT control position sensor. Refer to Exploded View .