Component Function Check

TESTING CONDITION:

• Before performing the following procedure, confirm that battery voltage is more than 12.8 V at idle.
• Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF.

GO TO 2 .

With CONSULT

1. Start engine and let it idle.
2. Select "BAT CUR SEN" in "DATA MONITOR" mode of "ENGINE" using CONSULT.
3. Check "BAT CUR SEN" indication for 10 seconds.

   "BAT CUR SEN"

   : above 2, 300 mv at least once

Without CONSULT

1. Start engine and let it idle.
2. Check the voltage between ECM harness connectors.

   ECM			Voltage
   Connector	+	-
   	Terminal
   F25	63	62	Above 2.3 V at least once

Is the inspection result normal?

YES

INSPECTION END

NO

Proceed to Diagnosis Procedure .