April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wake-up operation

BCM transmits the sleep wake up signal (wake up) to each unit when any of the CAN wake-up conditions are fulfilled. It changes from the low power consumption mode or the CAN communication sleep mode to the normal mode.
Each unit starts the transmission of CAN communication with the sleep wake up signal. In addition, the combination meter transmits the wake up signal to BCM via CAN communication to report the CAN communication start.

BCM wake-up condition

CAN wake-up condition

Door lock assembly LH: Lock or unlock
Door lock switch: OFF→ON
Door unlock switch: OFF→ON
Trunk opener switch: OFF→ON
Remote keyless entry receiver: Receiving valid keyfob

Receiving the sleep-ready signal (Not-ready) from any units
Push-button ignition switch (push switch): OFF→ON
Hazard switch: OFF→ON
PASSING switch: OFF→ON, ON→OFF
TAIL LAMP switch: OFF→ON
Driver door switch: OFF→ON, ON→OFF
Passenger door switch: OFF → ON, ON → OFF
Trunk switch: OFF→ON, ON→OFF
Driver door request switch: OFF→ON
Passenger door request switch: OFF→ON
Stop lamp switch 2 signal: ON
Remote keyless entry receiver: Receiving valid keyfob