Diagnostic Test

WARNING: This page is about a different car, the 2017 Nissan Versa Note. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION

CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE:
If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

GO TO STEP 2 .

REPLACE BCM

Replace BCM. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 3 .

WRITING VEHICLE SPECIFICATION

CONSULT
1. Enter "Re/Programming, Configuration".
2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to WORK PROCEDURE .
3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to WORK PROCEDURE .
Vehicles with remote keyless entry

GO TO STEP 4 .

Vehicles without remote keyless entry

GO TO STEP 6 .

REGISTER IGNITION KEYS

For initialization and registration of ignition keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

GO TO STEP 5 .

KEYFOB ID REGISTRATION

Perform keyfob ID registration. Refer to CONSULT Immobilizer mode and follow the on-screen instructions.

Work End.

REGISTER MECHANICAL KEYS

For initialization and registration of mechanical keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

Work End.