LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2019 >> Versa Note S >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Introduction And Basic Inspection) >> Basic Inspection >> Additional Service When Replacing TCM >> Work Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure

  1. CHECK NEW TCM PART NUMBER 

    Check new TCM part number to see whether it is blank TCM or not.

    NOTE:
    • Part number of blank TCM is 310F6-XXXXX.
    • Check the part number when ordering TCM or with the one included in the label on the container box.

    Is the new TCM a blank TCM?

    YES

    GO TO 2

    NO

    GO TO 3.

  2. SAVING TCM DATA (VEHICLE SPECIFICATIONS) 
    NOTE: Save necessary data stored in TCM in CONSULT according to the following instructions:

    SYMBOL With CONSULT

    1. Turn ignition switch OFF.
    2. Turn ignition switch ON.
    3. Select "Re/programming, Configuration".
    4. Select "AT/CVT".
      NOTE: If "AT/CVT" is not displayed and TCM data cannot be saved on CONSULT, GO TO 3.
    5. Select "Programming".
    6. Save TCM data on CONSULT according to the CONSULT display.

    GO TO 3.

  3. REPLACE TCM 
    1. Turn ignition switch OFF and wait for 10 seconds.
    2. Replace TCM. Refer to Removal and Installation .

    GO TO 4.

  4. LOAD CALIBRATION DATA 
    1. Shift the selector lever to the "P" position.
    2. Turn ignition switch ON.
    3. Check that "P" is displayed on shift position indicator on combination meter.
      NOTE: Displayed approximately 4 - 5 seconds after the selector lever is moved to the "P" position.

    Does the shift position indicator display "P"?

    YES

    GO TO 5.

    NO

    GO TO 8.

  5. STORE CALIBRATION DATA 
    1. Turn ignition switch OFF and wait for 5 seconds.
    2. Turn ignition switch ON.

    Does the shift position indicator display "P" at the same time when turning ON the ignition switch?

    YES

    GO TO 6.

    YES

    GO TO 7.

    NO

    Check harness between battery and TCM harness connector terminal. Refer to Diagnosis Procedure .

  6. WRITE TCM DATA (VEHICLE SPECIFICATIONS) 
    NOTE: Write data saved in CONSULT into a new TCM according to the following instructions:

    SYMBOL With CONSULT

    1. Select "Programming".
    2. Perform programming according to the CONSULT display.

    GO TO 7.

  7. CALIBRATE G SENSOR 

    Refer to Description .

    WORK END

  8. DETECT MALFUNCTIONING ITEM 

    Check the following items:

    • Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
    • Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Repair or replace the malfunctioning parts.

scientia non olet · About LEMON Manuals