Work Procedure

There is no vehicle specification in new IPDM E/R, so the vehicle specification needs to be written in IPDM E/R with CONSULT.

CAUTION:

When replacing IPDM E/R, always perform "Manual Configuration" with CONSULT. Or not doing so, IPDM E/R control function does not operate normally.
Never perform "Manual Configuration" except for new IPDM E/R or the control function may not operate normally.

WRITING MODE SELECTION
CONSULT

Select "CONFIGURATION" of IPDM E/R.

GO TO 2.
PERFORM "MANUAL CONFIGURATION"
CONSULT
1. Select "MANUAL CONFIGURATION".
2. Identify the correct model and configuration list.
  CAUTION:
  - Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
  - Make sure to select "SETTING" even if the indicated configuration of brand new IPDM E/R is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized
3. Sets the displayed item and then select "NEXT".
  NOTE: If item is not displayed, select "NEXT".
4. Check that the configuration has been successfully written and select "End".
GO TO 3.
OPERATION CHECK
Confirm that each function controlled by IPDM E/R operates normally.

Work End.