Data Monitor
|
Monitor item (Unit) |
Remarks |
|
BATTERY VOLT (V) |
Displays the power supply voltage for EPS control unit. |
|
TORQUE SENSOR (Nm) |
Displays steering wheel turning force detected by torque sensor. |
|
MOTOR CURRENT (A) |
Displays the current value consumed by EPS motor. *1 |
|
MOTOR SIG (A) |
Displays the current commanded value to EPS motor. |
|
ASSIST TORQUE (Nm) |
Displays assist torque of EPS motor being output by the electric power steering. |
|
C/U TEMP [ deg.C (deg.F)] |
Displays the temperature of inside of the EPS control unit. |
|
ASSIST LEVEL (%) |
Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls. However, it returns to 100% when left standing. *2 |
|
VEHICLE SPEED [km/h (MPH)] |
Vehicle speed is displayed from vehicle speed signal via CAN communication. *3 |
|
WARNING LAMP (On/Off) |
EPS warning lamp control status is displayed. |
*1: Almost in accordance with the value of "MOTOR SIG". It is not a malfunction though these values are not accorded when steering quickly.
*2: Normally displays 100%. In case of an excessive stationary steering, the assist curvature gradually falls. However, it returns to 100% when left standing.
*3: It is not a malfunction, though it might not be corresponding just after power switch is turned ON.