Work Procedure

STEP 1
1. Disconnect battery negative terminal or power main switch connector. Reconnect it after a minute or more.
2. Ignition switch ON.
3. Operate the power window switch to fully open the window. (This operation is not necessary if the window is already fully open).
4. Continue pulling the power window switch UP (AUTO-UP operation). Even after the glass stops at fully closed position, keep pulling the switch for 3 seconds or more.
5. Retest the AUTO-UP function operation.
GO TO 2.
STEP 2
Check anti-pinch function. Refer to Work Procedure .

Inspection End.