Active Test

The active test is used to determine and identify details of a malfunction, based on self-diagnosis test results and data obtained in the data monitor. In response to instructions from CONSULT, instead of those from chassis control module (with built in steering angle sensor) on the vehicle, a drive signal is sent to the actuator to check its operation.

CAUTION:

Never perform active test while driving the vehicle.
Always bleed air from brake system before active test.
Never perform active test when system is malfunctioning.

NOTE: During an active test, sometimes a chassis control warning is displayed and the master warning lamp illuminates on the information display in the combination meter; however, this is not a malfunction.

Test item	Operation	Description
BRAKE ACTUATOR 1 MODE 1	On	Controls brake fluid pressure.
BRAKE ACTUATOR 1 MODE 1	Off	Controls brake fluid pressure.
BRAKE ACTUATOR 1 MODE 2	On	Controls brake fluid pressure.
BRAKE ACTUATOR 1 MODE 2	Off	Controls brake fluid pressure.
MASTER WARNING ACTIVE	On	If touching "On" with the master warning lamp not illuminated, the master warning lamp illuminates. Stops in approximately 1 minute.
MASTER WARNING ACTIVE	Off	The master warning lamp turns OFF. (vehicle in normal state)