Configuration (BCM): Description

Vehicle specifications need to be written with CONSULT, because it is the not automatically write after replacing the BCM.

Configuration has follows.

Function			Description
Vehicle Configuration	Before ECU Replacement		Reads the vehicle configuration of the current BCM. Saves the read vehicle configuration.
	After ECU Replacement	FAST linked	NOTE: This item is displayed, but cannot be used.
		Manual selection	Writes the vehicle configuration with manual selection.
Operation Log Selection			Writes the read vehicle configuration.

CAUTION: When replacing the BCM, always perform "Re/programming, Configuration" with CONSULT, or not doing so, the BCM control function may not operate normally.

After installing a new BCM service part, if the Intelligent Key UNLOCK button is pressed before performing the configuration with CONSULT-III plus, certain BCM configuration parameters will be permanently locked in the default setting; one of these parameter is Remote Engine Start.

Complete the procedure of "Re/programming, Configuration" in order.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Never save vehicle configuration to the BCM used by other cars.
If you set incorrect vehicle configuration, incidents might occur.

It is not necessary to register Intelligent Keys to a new BCM.

Before pairing of the BCM and HFM, always write the BCM configuration, or not doing so, the BCM control function will not operate normally.