Application Items

CONSULT can display each diagnostic item using the diagnostic test modes as follows.

Diagnosis mode	CGW Status			Description
Diagnosis mode	Restricted Mode	Diag Test Mode	Open Mode	Description
Self Diagnostic Result	Display	Display	Display	Display non-network DTC which chassis control module (with built in steering angle sensor) memorizes
CGW Information	Display	Display	Display	Display the current CGW mode Enables CGW to switch mode
Data Monitor	Display	Display	Display	Displays chassis control module (with built in steering angle sensor) input/output data in real time
Active Test	Non-display	Display	Display	Enables an operational check of a load by transmitting a driving signal from the chassis control module (with built in steering angle sensor) to the load
ECU Identification	Display	Display	Display	Displays chassis control module (with built in steering angle sensor) part number
Re/programming, Configuration	Display	Display	Display	The vehicle specification that is written in chassis control module (with built in steering angle sensor) can be displayed or stored The vehicle specification can be written when chassis control module (with built in steering angle sensor) is replaced
Network-DTC	Display	Display	Display	Display network DTC which chassis control module (with built in steering angle sensor) memorizes when performing "Diagnosis (All System)".
CAN Diag Support Monitor ^*	Display	Display	Display	NOTE: The mode is indicated, but not monitored

*: Displays when performing "Diagnosis (All System)".