Component Function Check

START
Make sure that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5, 000 km (3, 107 miles)
- Atmospheric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm ² , 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30 deg. C (68 - 86 deg. F)
- Engine coolant temperature: 75 - 95 deg. C (167 - 203 deg. F)
- Transmission: Warmed-up
  - After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SEN" (CVT fluid temperature sensor signal) indicates more than 60 deg. C (140 deg. F).
- Electrical load: Not applied*
- Engine speed: Idle
*: Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.

GO TO 2.
CHECK REFERENCE OF DATA MONITOR MODE
With CONSULT

NOTE: Perform "Reference" in "DATA MONITOR" mode in maximum scale display.
1. Refer to Work Procedure .
2. On CONSULT screen, select "ENGINE">>"Data Monitor".
3. Select "Reference" and change "DISPLAY TYPE" to "Line Graph".
4. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MASS AIR FLOW SENSOR (Hz)".
5. Make sure that monitor items are within the SP value.
Is the inspection result normal?

YES

END

NO

Refer to Diagnosis Procedure .