Symptom Table

CONSULT

1. Perform "Data Monitor" of CONSULT to check for any malfunctioning item.
2. Check the malfunction combinations.

   Malfunction item: x

   Data monitor item

   Combination switch circuit

   INPUT 1

   INPUT 2

   INPUT 3

   INPUT 4

   INPUT 5

   INPUT 6

   OUTPUT 1

   OUTPUT 2

   OUTPUT 3

   OUTPUT 4

   OUTPUT 5

   OUTPUT 6

   Check diode 1

   x

   x

   High beam switch

   x

   x

   Passing switch

   x

   x

   Front fog switch

   x

   x

   INT volume 1

   x

   x

   Check diode 2

   x

   x

   Low beam switch

   x

   x

   AUTO light switch

   x

   x

   Tail lamp switch

   x

   x

   Front washer switch

   x

   x

   Check diode 3

   x

   x

   Turn signal LH

   x

   x

   Turn signal RH

   x

   x

   Front wiper LO

   x

   x

   Front wiper HI

   x

   x

   Front wiper INT

   x

   x

   Check diode 4

   x

   x

   Light OFF switch

   x

   x

   INT volume 2

   x

   x

   INT volume 3

   x

   x

   Check diode 5

   x

   x

   Front wiper OFF

   x

   x

   Front wiper MIST

   x

   x

   Check diode 6

   x

   x

3. Identify the malfunctioning part from the agreed combination and repair or replace the part.

   Malfunctioning part	Repair or replace
   Combination switch INPUT circuit	Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
   Combination switch OUTPUT circuit	Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
   All Items	Replace BCM. Refer to Removal and Installation .
   If only one item is detected or the item is not applicable to the combinations	Replace combination switch. Refer to Removal and Installation .
   All Items are normal	Check intermittent incident. Refer to Intermittent Incident .