Component Inspection
- CHECK CRANKSHAFT POSITION SENSOR (POS)-1
- Turn ignition switch OFF.
- Loosen the fixing bolt of the sensor.
- Disconnect crankshaft position sensor (POS) harness connector.
- Remove the sensor.
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace crankshaft position sensor (POS). Refer to Exploded View .
- CHECK CRANKSHAFT POSITION SENSOR (POS)-2
Check resistance between crankshaft position sensor (POS) terminals as follows.
CKP sensor 1
Condition
Resistance
Terminal
1
2
Temperature
25 deg. C (77 deg. F)
Except 0 Ohms
3
2
3
Is the inspection result normal?
YES
INSPECTION END
NO
Replace crankshaft position sensor (POS). Refer to Exploded View .