Detailed Flow

GET INFORMATION FOR SYMPTOM
1. Get the detailed information about symptom from customer.
2. Check the drive mode indicator on the meter appeared.
3. Check the Drive mode indicator on the meter changed when operates the drive mode selector switch.
GO TO 2.
CHECK THE DTC
1. Check DTC of "All DTC Reading".
2. Perform the following procedure if DTC is displayed.
  - Record DTC and freeze frame data. (Or, write it down.)
3. Check related service bulletins for information.
Are any DTCs detected?

YES

GO TO 3.

NO

GO TO 4.
CONFIRM THE FAIL-SAFE CONDITION
Confirm the fail-safe condition of detected DTC. Refer to Fail-safe .

Are there any DTCs that causes drive mode selector function is suspended?

YES

GO TO 5.

NO

GO TO 4.
CHECK INFORMATION DISPLAY ON COMBINATION METER
1. Ignition switch OFF and wait at least 10 seconds.
2. Ignition switch ON.
3. Check that STANDARD is displayed on the information display screen of the combination meter. (2WD models)
4. Check that AUTO is displayed on the information display screen of the combination meter. (AWD models)
5. Check that the view of information display change when switching up and down the drive mode select switch. (2WD models)
6. Check that the view of information display change when switching left and right the drive mode select switch. (AWD models)
Is the inspection result normal?

YES

GO TO 5.

NO

GO TO 6.
PERFORM DIAGNOSES FOR ERROR-CAUSING SYSTEM
Perform the trouble diagnosis of components that DTC indicated.

GO TO 9.
CHECK THE AXLE TYPE
Check the axle type.

2WD models

GO TO 8.

AWD models

GO TO 7.
CHECK THE INDICATOR ON DRIVE MODE SELECT SWITCH (AWD MODELS)
1. Ignition switch OFF and wait at least 10 seconds.
2. Ignition switch ON.
3. Check the indicator of STANDARD on drive mode select switch indicator.
4. Check the illuminated position changes according to the operation when switching the drive mode select switch.
Is the inspection result normal?

YES

GO TO 10.

NO

GO TO 8.
CHECK DRIVE MODE SELECT SWITCH CIRCUIT
Check drive mode select switch circuit. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO 10.

NO

GO TO 9.
REPAIR OR REPLACE THE MALFUNCTION PART
Repair or replace the malfunctioning part.

GO TO 11.
CHECK COMBINATION METER
Check the COMBINATION METER.
- Full TFT meter: Refer to On Board Diagnosis Function .
- 7 inch information display: Refer to On Board Diagnosis Function .
GO TO 11.
FINAL CHECK
1. Check that the symptom is not detected.
2. Perform DTC Confirmation Procedure again, and then check that the malfunction is repaired.
Is DTC detected and/or does symptom remain?

YES

GO TO 5.

YES

GO TO 4.

NO

INSPECTION END