Work Procedure

WARNING: This page is about a different car, the 2021 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- System description for I-DA: Refer to System Description .
- Handling precaution: Refer to Precautions for I-DA .

CHECK I-DA SYSTEM SETTING
1. Start the engine.
2. After starting the engine wait for 30 seconds or more.
3. Check that the I-DA system setting can be enabled/disabled on the information display.
4. Turn OFF the ignition switch and wait for 5 seconds or more.
5. Check that the previous setting is saved when the engine starts again.
GO TO 2.

ACTION TEST FOR I-DA

Enable the setting of the I-DA system on the information display.

Check the I-DA operation according to the following table.

Vehicle condition/ Driver's operation				Display on combination meter
I-DA OFF				--
I-DA ON				Courtesy of NISSAN NORTH AMERICA, INC.

INSPECTION END