Work Procedure

WARNING: This page is about a different car, the 2021 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Since vehicle specifications are not included in the distance sensor after replacement, it is required to write vehicle specifications with CONSULT.

Configuration has three functions as follows.

Function		Description
Read/Write Configuration	Before Replace ECU	Allows the reading of vehicle specification written in distance sensor to store the specification in CONSULT.
	After Replace ECU	Allows the writing of the vehicle information stored in CONSULT into the distance sensor.
Manual Configuration		Allows the writing of the vehicle specification into the distance sensor by hand.

CAUTION:

Use "Manual Configuration" only when "Parts number" of distance sensor cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING PARTS NUMBER
WITH CONSULT
1. Select "Before Replace ECU" of "Read/Write Configuration".
2. Check that "Parts number" is displayed on CONSULT.
Is "Parts number" displayed?

YES

GO TO 2.

NO

GO TO 6.
VERIFYING PARTS NUMBER (1)
WITH CONSULT

Compare a "Parts number" displayed on the CONSULT screen with the one searched by using EPC (service parts catalog) to check that these "Parts number" agree with each other.

NOTE: For the "Parts number" searched by using EPC (service parts catalog), use the last five digits of the "Parts number".

GO TO 3.
SAVING PARTS NUMBER
WITH CONSULT

Save "Parts number" on CONSULT.

GO TO 4.
REPLACE DISTANCE SENSOR (1)
Replace distance sensor. Refer to Removal and Installation .

GO TO 5.
WRITING (AUTOMATIC WRITING)
WITH CONSULT
1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
2. Select the "Parts number" agreeing with the one stored on CONSULT and the one searched by using EPC (service parts catalog) to write the "Parts number" into the distance sensor.
GO TO 8.
REPLACE DISTANCE SENSOR (2)
Replace distance sensor. Refer to Removal and Installation .

GO TO 7.
WRITING (MANUAL WRITING)
WITH CONSULT
1. Select "Manual Configuration".
2. Select the "Parts number" searched by using EPC (service parts catalog) to write the "Parts number" into the distance sensor.
  NOTE: For the "Parts number" searched by using EPC (service parts catalog), use the last five digits of the "Parts number".
GO TO 8.
VERIFYING PARTS NUMBER (2)
WITH CONSULT

Compare a "Parts number" displayed on the CONSULT screen with the one searched by using EPC (service parts catalog) to check that these "Parts number" agree with each other.

NOTE: For the "Parts number" searched by using EPC (service parts catalog), use the last five digits of the "Parts number".

GO TO 9.
OPERATION CHECK
Confirm that each function controlled by distance sensor operates normally.

WORK END