Work Procedure

SAVE VIN DATA (AV CONTROL UNIT)
1. CONSULT Perform "SAVE VIN DATA" to save current VIN data.
>>

GO TO 2.
SAVE "OPERATION LOG"
1. CONSULT Save Operation Log, according to the procedure of "Programming" in Operation Manual.
  NOTE: AV control unit part number is saved in "Operating Log" saved in CONSULT.
>>

GO TO 3.
REPLACE AV CONTROL UNIT
1. Replace AV control unit. Refer to AV CONTROL UNIT : Removal and Installation .
>>

GO TO 4.
CHECK "OPERATION LOG"
1. CONSULT Check "Operation Log" saved before replacing the AV control unit, according to the procedure of "Programming" in Operation Manual.
  NOTE: For the vehicle that the programming is to be performed, check if "Operation Log" of parts number is in Saved Data List.
Is there an applicable Operation Log in the Saved Data List?

YES>>

GO TO 5.

NO>>

GO TO 6.
PERFORM AV CONTROL UNIT PROGRAMMING
1. CONSULT Perform AV control unit programming, according to "Programming" of Operation Manual. Refer to Operation Manual.
  CAUTION:
  During programming, maintain the following conditions:
  - Ignition switch: ON
  - Electric load: OFF
  - Brake pedal: Not depressed
  - 12 V battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)
>>

GO TO 8.
READ IN AV CONTROL UNIT PART NUMBER BY "FAST LINKED"
1. CONSULT Obtain AV control unit part number by NISSAN PARTS CATALOG GLOBAL Web-FAST, according to the procedure of "FAST linked" in Operation Manual. Refer to Operation Manual.
  CAUTION:
  Be sure select "FAST linked".
  
  NOTE: "FAST linked" allows an appropriate programming by obtaining ECU part number from NISSAN PARTS CATALOG GLOBAL Web-FAST even when the part number cannot be obtained from the old ECU used before replacing with a new one.
>>

GO TO 7.
PERFORM PROGRAMMING (FAST LINKED)
1. CONSULT Perform AV control unit programming according to the procedure of FAST linked in Operation Manual. Refer to Operation Manual.
  CAUTION:
  During programming, maintain the following conditions:
  - Ignition switch: ON
  - Electric load: OFF
  - Brake pedal: Not depressed
  - 12 V battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)
>>

GO TO 8.
CONFIGURATION (AV CONTROL UNIT)
1. CONSULT Perform configuration. Refer to Work Procedure .
>>

GO TO 9.
WRITE VIN DATA (AV CONTROL UNIT)
1. CONSULT Perform "WRITE VIN (SAVED DATA)" or "WRITE VIN (MANUAL INPUT)" to write VIN data.
>>

Work End.