Work Support

1. CONSULT Select "Re/programming, Configuration" of "MULTI AV".

When writing saved data>>

GO TO 2.

When writing manually>>

GO TO 3.

1. CONSULT Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to AV control unit.
   CAUTION:

   Do not perform any operation such as the navigation operation during configuration writing.

>>

GO TO 4.

1. CONSULT
   1. Select "Re/programming, Configuration" of "MULTI AV".
   2. Select "Manual Configuration", and write the setting value as shown in the following table to AV control unit according to the vehicle specification.
      CAUTION:

      Grasp vehicle specifications precisely. The control of ECU control may not function normally if the specifications are misread.

      NOTE:

      • The items shown in the list depend on vehicle specifications.
      • The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
      • If selection items are not displayed on the CONSULT screen, touch "NEXT".

      MANUAL SETTING ITEM		Detail
      Items	Setting value
      NAVIGATION	WITH	Models with navigation system
      	WITHOUT	Models without navigation system
      SOUND SYSTEM	BOSE	Models with Bose audio
      	NORMAL 6SPKS	Models without Bose audio
      CAMERA SYSTEM	NONE or AVM ph3	Models with Intelligent around view monitor system
      	REAR	Models with rear view monitor system
      SONAR TYPE	None	Models without sonar
      	REAR	Models with sonar
      PREDICTIVE COURSE LINE	Without or with (with AVM)	Models with Intelligent around view monitor or without camera
      	With (Rear view camera)	Models with rear view monitor

>>

GO TO 4.

1. CONSULT Select "Self Diagnostic Result" mode of "MULTI AV", and check whether or not DTC B1341-55 is detected.

Is DTC B1341-55 detected?

YES>>

GO TO 1.

NO>>

GO TO 5.

1. Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.

YES>>

Work End.