DTC Diagnosis Procedure

1. Perform programming of the EPS control unit. Refer to Work Procedure .

>>

GO TO 2

1. CONSULT
   1. Ignition switch OFF to ON.
   2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
   3. Ignition switch OFF and wait for at least 10 seconds.
   4. Ignition switch OFF to ON.
   5. Select "Self Diagnostic Result" mode of "EPS/DAST 3".
   NOTE: Replace the EPS control unit even if other DTCs are displayed along with "C1602" in self-diagnosis for "EPS/DAST 3".

Is DTC detected?

YES>>

EPS control unit is malfunctioning. Replace EPS control unit. Refer to EPS CONTROL UNIT : Removal and Installation .

NO>>

Inspection End.