Work Procedure

CALIBRATION OF DECEL G SENSOR

CAUTION:

To calibrate the decel G sensor, make sure to use CONSULT (Calibration cannot be done without CONSULT)

ALIGN THE VEHICLE STATUS
1. Stop vehicle with front wheels in straight-ahead position.
>>

GO TO 2.
PERFORM CALIBRATION OF DECEL G SENSOR
1. CONSULT
  1. Select "DECEL G SEN CALIBRATION" in "Work support" mode of "ABS".
  2. Select "Start".
  3. After approximately 10 seconds, select "End".
    NOTE: After approximately 60 seconds, it ends automatically.
  4. Ignition switch OFF -> ON.
    CAUTION:
    Be sure to perform above operation.
>>

GO TO 3.
CHECK DATA MONITOR
1. CONSULT
  1. Run vehicle with front wheels in straight-ahead position, then stop.
  2. Select "Data Monitor" mode. Then make sure "DECEL G SEN" is within ± 0.08 G.
Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Perform calibration of decel G sensor again, GO TO 1.
ERASE THE SELF DIAGNOSTIC RESULT MEMORY
1. Erase the "Self Diagnostic Result" memory of the ABS actuator and electric unit (control unit) and ECM.
  - ABS actuator and electric unit (control unit): Refer to CONSULT Function (ABS) .
  - ECM: Refer to CONSULT Function .
Are the memories erased?

YES>>

Inspection End.

NO>>

Check the items indicated by the "Self Diagnostic Result".