DTC Diagnosis Procedure

1. CONSULT
   1. Ignition switch OFF to ON.
   2. Erase self-diagnostic results for "EPS/DAST 3".
   3. Pull the parking brake switch.
      NOTE: Check to make sure that the parking brake switch indicator is turned ON.
   4. Ignition switch OFF.
   5. Get out of the vehicle and close all doors.
   6. Wait 65 seconds.
      NOTE:

      • Check to make sure that the parking brake switch indicator is turned OFF.
      • If the rear brake calipers are hot, wait up to an hour until parking brake indicator light on the switch turns OFF. Once indicator light on the switch turns OFF, move to next step.
   7. Start the engine.
      CAUTION:

      Never drive the vehicle.

   8. Perform self-diagnosis for "EPS/DAST 3".

Is DTC "C1608-49" detected?

YES>>

Replace the power steering control module (steering gear assembly). Refer to Removal and Installation .

NO>>

Check terminals and connection of each harness connector for malfunctioning conditions.