Work Procedure

Since vehicle specifications are not included in the front camera unit after replacement, it is required to write vehicle specifications with CONSULT.

Configuration has three functions as follows.

Function		Description
Read/Write Configuration	Before Replace ECU	Allows the reading of vehicle specification written in front camera unit to store the specification in CONSULT.
Read/Write Configuration	After Replace ECU	Allows the writing of the vehicle information stored in CONSULT into the front camera unit.
Manual Configuration		Allows the writing of the vehicle specification into the front camera unit by hand.

CAUTION:

Use "Manual Configuration" only when "Parts number" of front camera unit cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING PARTS NUMBER
1. WITH CONSULT
  1. Select "Before Replace ECU" of "Read/Write Configuration".
  2. Check that "Parts number" is displayed on CONSULT.
Is "Parts number" displayed?

YES>>

GO TO 2.

NO>>

GO TO 6.
VERIFYING PARTS NUMBER (1)
1. WITH CONSULT Compare a "Parts number" displayed on the CONSULT screen with the one searched by using EPC (service parts catalog) to check that these "Parts number" agree with each other.
  NOTE: For the "Parts number" searched by using EPC (service parts catalog), use the last five digits of the "Parts number".
>>

GO TO 3.
SAVING PARTS NUMBER
1. WITH CONSULT Save "Parts number" on CONSULT.
>>

GO TO 4.
REPLACE FRONT CAMERA UNIT (1)
1. Replace front camera unit. Refer to Removal and Installation .
>>

GO TO 5.
WRITING (AUTOMATIC WRITING)
1. WITH CONSULT
  1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
  2. Select the "Parts number" agreeing with the one stored on CONSULT and the one searched by using EPC (service parts catalog) to write the "Parts number" into the front camera unit.
>>

GO TO 8.
REPLACE FRONT CAMERA UNIT (2)
1. Replace front camera unit. Refer to Removal and Installation .
>>

GO TO 7.
WRITING (MANUAL WRITING)
1. WITH CONSULT
  1. Select "Manual Configuration".
  2. Select the "Parts number" searched by using EPC (service parts catalog) to write the "Parts number" into the front camera unit.
    NOTE: For the "Parts number" searched by using EPC (service parts catalog), use the last five digits of the "Parts number".
>>

GO TO 8.
VERIFYING PARTS NUMBER (2)
1. WITH CONSULT Compare a "Parts number" displayed on the CONSULT screen with the one searched by using EPC (service parts catalog) to check that these "Parts number" agree with each other.
  NOTE: For the "Parts number" searched by using EPC (service parts catalog), use the last five digits of the "Parts number".
>>

GO TO 9.
OPERATION CHECK
1. Confirm that each function controlled by front camera unit operates normally.
>>

WORK END