Confirmation Procedure

1. If "Confirmation Procedure" has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

1. CONSULT
   1. Ignition switch ON.
   2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC "C161C-87" detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO>>

Confirmation after repair: Inspection End.