Work Procedure (Group A)
| *1: | When the same malfunction is detected in two consecutive trips, MIL will illuminate. |
- CHECK DTC
Check DTC. Is any DTC detected?
YES>>
Repair malfunction (s) and erase DTC.
NO>>
GO TO 2.
- CHECK PERMANENT DTC
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- On CONSULT screen, select "SRT and P-DTC">>"Permanent DTC Status".
With GST
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Select Service $0A with GST.
Is any permanent DTC detected?
YES>>
GO TO 3.
NO>>
END
- PERFORM DTC CONFIRMATION PROCEDURE
Perform "DTC CONFIRMATION PROCEDURE" for DTCs which are the same as permanent DTCs stored in ECM. Refer to DTC Index .
>>
GO TO 4.
- CHECK PERMANENT DTC
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- On CONSULT screen, select "SRT and P-DTC">>"Permanent DTC Status".
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Select Service $0A with GST.
Is any permanent DTC detected?
YES>>
GO TO 1.
NO>>
END