Work Procedure

If any of the following operations are performed, the initialization is necessary for normal operation of power window system.

• Disconnection and connection of battery cable from negative terminal.
• When power window switch replaced.
• Electric power supply to power window switch or power window motor is interrupted by blown (open) fuse or disconnection and connection of the negative terminal of battery, etc.
• Disconnection and connection of power window switch harness connector.
• Removal of power window motor from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of glass.

• Auto up operation
• Anti-pinch function
• Retained power function
• Automatic window adjusting function
• Keyless power window down function

1. SYSTEM INITIALIZATION 
   1. Close the door.
   2. Ignition switch ON.
   3. Operate power window switch to fully open the door glass.
      • This operation is unnecessary if the door glass is already fully open.
   4. Continue pulling the power window switch UP (AUTO-UP operation). Even after door glass stops at fully closed position, keep pulling the switch for 2 seconds or more.
   5. Check that AUTO UP function operates normally.

   >>

   GO TO 2.

2. ANTI-PINCH INSPECTION 

   Check anti-pinch function. Refer to Work Procedure .

   >>

   END