Component Inspection

1. Turn ignition switch OFF.
2. Disconnect engine oil temperature sensor harness connector.
3. Remove engine oil temperature sensor.
4. Check resistance between engine oil temperature sensor terminals by heating with hot water as shown in the figure, below.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Terminals	Condition		Resistance (kΩ)
   1 and 2	Temperature [°C (°F)]	20 (68)	2.35 - 2.73
   		50 (122)	0.68 - 1.00
   		90 (194)	0.236 - 0.260

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace engine oil temperature sensor. Refer to OIL PAN (LOWER) AND OIL STRAINER : Exploded View .